0 Membres et 1 Invité sur ce sujet
1) How to install Neutrino HD over Official FirmwareDownload Neutrino HD software package which contains patch.bin and neutrino.bin file inside.Copy patch.bin fi le to your USB Memory stick (FAT32 formatted)Put the USB Stick into AZBox device and start the updating procedure trough Settings menu or byturning off and then turning on your AZBox.When initial software is installed, your AZBox will displayed IP address. (Note: for Ultra model, youhave to note the IP address from the Settings menu or from your router, as it doesn’t have display).Run Neutrino Loader 1.1 and enter the IP address (which was shown before) int the IP address field of Neutrino Loader 1.1. Press button Upload.Once Upload button is pressed, Neutrino Loader will ask you to specify which file you want to beloaded. Please, select neutrino.bin file from Neutrino HD package.After this flashing procedure starts, please wait until Neutrino Loader confirm you that performingoperations are finished.When you get the confirmation message from Neutrino Loader, please remove the USB memorystick from your AZBox.2) From Neutrino HD back to OFWThis manual will help You to go back from Neutrino HD to Official Firmware.Turn OFF Your AZBox HD device by Power switch on rear panelNow turn it ON, and keep pressed VOL+ button on remote controlAfter max. 20 seconds IP will be displayed on AZBox HD displayStart Neutrino LoaderUnpack archive called Neutrino HD to Official Firmware.zip.Enter IP address shown on AZBox HD display in IP address fi eld of Neutrino Loader.Press button Upload, after which Neutrino Loader will ask You to specify which file You want to load in AZBox HD.Locate file called patch.bin in Neutrino HD to Offi cial Firmware folder, and select it.Please wait until process is finished after which Neutrino Loader will display message Kernel installed successfully.Turn OFF AZBox HD device, and connect to Your receiver USB Memory stick on which you previously place Offi cial Firmware patch.bin file.Turn ON AZBox HD and follow standard Official Firmware UPDATE procedure.3) From E2 to Neutrino HDAs with E2, except use the Neutrino Loader instead of AZUp or JAZUp...-first install the Neutrino Loader to your PC/laptop, like any other application-put AZbox HD into rescue Mode and do as usual with E2, using Neutrino Loader you just installed4) From Neutrino back to E2 (thanx dvlajkovic!)-use Neutrino Loader to put the special patch.bin file to return to OFW-theother patch.bin goes to USB stick in order to go from OFW to E2 (this one is from RTi Team)-switch off AZbox-plug in USB stick-turn on AZbox and do the usual upgrade procedure from USB stick, by which you get AZbox HD to give you its IP address on its VFD-do the JAZUp/AzUP regular thing to put in E2.
8/12/2011A new AZtrino v1.1 for Premium HD, Premium HD+, Elite HD and Ultra HD, is now available
es ce qu il y a qq qui a testé cette image
